Medica hard coating
A special metal-crosslinked dispersion care product. Protects the floor with an elastic, slip-resistant, satin-gloss care film with increased resistance to disinfectants and alcohol-based preparations compared to conventional hard sealants (e.g., Dr. Schutz Secura Hard Sealant). Dirt adhesion is reduced and routine cleaning is facilitated. Also suitable for high-speed cleaning of the care film.
Product description
Special water-based polymer coating. Glossy. For the initial care and refreshment of deep-cleaned or post-construction clean non-absorbent floors. For professional use in buildings. Recommended in the healthcare sector for cleanability and optimized disinfection.
− With increased resistance to disinfectants and alcohol-based preparations compared to conventional hard coatings. Further resistance enhancement and a matte surface appearance are possible with a 2K lacquer sealant.
− Reduces dirt adhesion and maintenance effort.
− High solid content.
− Wax-containing polymer dispersion, without zinc, without TBEP.
− Suitable for high-speed treatment film restoration.
Suitable for closed-pore, non-absorbent surfaces.
− PVC / LVT
− Linoleum, if open-pored after priming with Lino Primer.
− Sealed wooden floors
− The application on PU/EP self-levelling coatings, polyolefin, rubber and stone floors must be tested on a project-specific basis.
Please refer to our flooring and property-specific care instructions at www.dr-schutz.com.
Application
Shake well. Apply undiluted at a temperature of at least 15°C using the Dr. Schutz Wischwiesel or Dr. Schutz Profi Wischmop in an even, thin film to the final-cleaned or thoroughly cleaned and dried surface in the direction of installation. For increased protection, repeat the application when the protective film is firm to touch.
Notes
− The substrate must be professionally prepared. It must be free of any care product residue and any old, non-adherent coatings, and be roughened, clean, dry, and free of oil, wax, and dust. (*)
− Avoid strong sunlight and drafts when applying.
− Turn off the underfloor heating in good time beforehand.
− If necessary, further orders can be placed after intensive cleaning.
− The floor and material temperature must not be below +15°C during application and drying.
Optimal conditions are in the range of 18-25 °C.
consumption
25-30 g/m² per application (coverage: 30-40 m²/l)
